FAQ
Frequently Asked Questions
What areas do you service?
That’s going to be a long list so we placed it on a separate page for you! Click here.
What is the difference between cement and concrete?
Although the terms cement and concrete often are used interchangeably, cement is actually an ingredient of concrete. Concrete is basically a mixture of aggregates and paste. The aggregates are sand and gravel or crushed stone; the paste is water and portland cement. Concrete gets stronger as it gets older. Portland cement is not a brand name, but the generic term for the type of cement used in virtually all concrete, just as stainless is a type of steel and sterling a type of silver. Cement comprises from 10 to 15 percent of the concrete mix, by volume. Through a process called hydration, the cement and water harden and bind the aggregates into a rocklike mass. This hardening process continues for years meaning that concrete gets stronger as it gets older.So, there is no such thing as a cement sidewalk, or a cement mixer; the proper terms are concrete sidewalk and concrete mixer.
What is air-entrained concrete?
Air-entrained concrete contains billions of microscopic air cells per cubic foot. These air pockets relieve internal pressure on the concrete by providing tiny chambers for water to expand into when it freezes. Air-entrained concrete is produced through the use of air-entraining portland cement, or by the introduction of air-entraining agents, under careful engineering supervision as the concrete is mixed on the job. The amount of entrained air is usually between 4 percent and 7 percent of the volume of the concrete, but may be varied as required by special conditions.
Why test concrete?
Concrete is tested to ensure that the material that was specified and bought is the same material delivered to the job site. There are a dozen different test methods for freshly mixed concrete and at least another dozen tests for hardened concrete, not including test methods unique to organizations like the Army Corps of Engineers, the Federal Highway Administration, and state departments of transportation.
What is 3,000 pound concrete?
It is concrete that is strong enough to carry a compressive stress of 3,000psi (20.7 MPa) at 28 days. Concrete may be specified at other strengths as well. Conventional concrete has strengths of 7,000 psi or less; concrete with strengths between 7,000 and 14,500 psi is considered high-strength concrete.
How do you remove stains from concrete?
Stains can be removed from concrete with dry or mechanical methods, or by wet methods using chemical or water.
Common dry methods include sandblasting, flame cleaning and shotblasting, grinding, scabbing, planing and scouring. Steel-wire brushes should be used with care because they can leave metal particles on the surface that later may rust and stain the concrete. Wet methods involve the application of water or specific chemicals according to the nature of the stain. The chemical treatment either dissolves the staining substance so it can be blotted up from the surface of the concrete or bleaches the staining substance so it will not show. To remove blood stains, for example, wet the stains with water and cover them with a layer of sodium peroxide powder; let stand for a few minutes, rinse with water and scrub vigorously. Follow with the application of a 5 percent solution of vinegar to neutralize any remaining sodium peroxide.
Top 10 Reasons to Install a Concrete Patio
1. Staining and sealing a wood deck every year can be a lot of work!
2. Concrete can be stamped, engraved, stenciled or textured to resemble pricier stone or brick pavers—and often at a fraction of the cost.
3. With the uses of stains and other coloring methods, you can achieve just about any hue imaginable, whether you want to match the stone facade of your house or blend in with the natural landscape.
4. Concrete is easily formed into any shape to accommodate backyard space restrictions.
5. Unlike paving stones, you won’t have sand-filled joints between units where grass and weeds can sprout.
6. Concrete is durable and can stand up to a range of weather conditions found across the country.
7. Thanks to the design versatility of concrete, your patio will never look just like your neighbor’s.
8. The aesthetic appeal and durability of decorative concrete will boost the resale value of your home.
9. Your concrete patio won’t be vulnerable to termite infestation, wood rot or splintering.
10. Concrete is environmentally friendly. Installing a concrete patio rather than a wood deck saves lumber and eliminates the need for regular maintenance with solvent-based wood stains and sealers.
What does it mean to “cure” concrete?
Curing is one of the most important steps in concrete construction, because proper curing greatly increases concrete strength and durability. Concrete hardens as a result of hydration: the chemical reaction between cement and water. However, hydration occurs only if water is available and if the concrete’s temperature stays within a suitable range. During the curing period-from five to seven days after placement for conventional concrete-the concrete surface needs to be kept moist to permit the hydration process. new concrete can be wet with soaking hoses, sprinklers or covered with wet burlap, or can be coated with commercially available curing compounds, which seal in moisture.
Can it be too hot or too cold to place new concrete?
Temperature extremes make it difficult to properly cure concrete. On hot days, too much water is lost by evaporation from newly placed concrete. If the temperature drops too close to freezing, hydration slows to nearly a standstill. Under these conditions, concrete ceases to gain strength and other desirable properties. In general, the temperature of new concrete should not be allowed to fall below 50 Fahrenheit (10 Celsius) during the curing period.
Why does concrete crack?
Concrete, like all other materials, will slightly change in volume when it dries out. In typical concrete this change amounts to about 500 millionths. Translated into dimensions-this is about 1/16 of an inch in 10 feet (.4 cm in 3 meters). The reason that contractors put joints in concrete pavements and floors is to allow the concrete to crack in a neat, straight line at the joint when the volume of the concrete changes due to shrinkage.
What does 28 -day strength mean?
Concrete hardens and gains strength as it hydrates. The hydration process continues over a long period of time. It happens rapidly at first and slows down as time goes by. To measure the ultimate strength of concrete would require a wait of several years. This would be impractical, so a time period of 28 days was selected by specification writing authorities as the age that all concrete should be tested. At this age, a substantial percentage of the hydration has taken place.
What is stamped concrete?
Stamped concrete, commonly referred to as patterned concrete or imprinted concrete, is concrete that is designed to resemble brick, slate, flagstone, stone, tile and even wood. In this section you will see how stamped concrete can be used to beautify pool decks, driveways, entries, courtyards, and patios.
Due to the wide array of options when it comes to concrete pattern, concrete colors, and the cost of stamped, or imprinted concrete in relation to the materials it is a substitute for, the choice of stamped concrete is becoming more popular and frequent.
Colors and patterns for stamped cement are often chosen to blend with other stone, tile or patterned concrete elements at the residence. Complex designs incorporating steps, courtyards, and fountains can be achieved when patterns are pressed into the concrete. Stamped concrete can also be blended with other decorative concrete elements such as exposed aggregate finishes and acid-etch staining, along with a particular pattern, such as running bond brick, hexagonal tile, worn rock or stone. Concrete provides the perfect canvas for creating an economical replica of more expensive materials, and yet still maintaining a very natural, authentic look.
How to clean and seal your concrete:
Cleaning your concrete periodically and keeping it sealed with the right concrete sealers are the key components of any good maintenance program. How often you clean and reseal will largely depend on the conditions the concrete is exposed to, especially weather extremes, sunlight intensity and the amount of foot or vehicle traffic. Be sure to ask your concrete contractor to recommend cleaning and maintenance products appropriate for your pavement type and exposure conditions. If you have a big area to maintain or simply don’t want to tackle the work yourself, let us know and we will schedule an estimate for you.